Data-Linc Group DLM4100 Guide de l'utilisateur télécharger pdf (Page 13)

DLM4100 User’s Manual

P/N 161-09977-001B

S21 General Bit-Mapped Options: S21 reflects the state of several “AT” commands.

Bit 0-2 Not used

Bit 3-4 0=DTR ignored (&D0)

1=Enter command mode on DTR off (&D1)

2=Disconnect on DTR off (&D2)

3=Reset on DTR off (&D3)

Bit 5 0=DCD always active (&C0)

1=DCD on with carrier (&C1)

Bit 6 0=DSR always active (&C0)

1=DSR on when modem ready (&C1)

Bit 7 0=No disconnect on space (ATY0)

1=Disconnect on space (ATY1)

S22 General Bit-Mapped Options: S22 reflects the stat of several “AT” commands.

Bit 0-1 0=Low speaker volume (ATL0)

1=Low speaker volume (ATL1)

2=Moderate speaker volume (ATL2)

3=High speaker volume (ATL3)

Bit 2-3 0=Speaker off (ATM0)

1=Speaker off with carrier (ATM1)

2=Speaker always on (ATM2)

3=Speaker on during handshake (ATM3)

Bit 4-6 0=Basic result codes (ATX0)

4=Connect speed result codes (ATX1)

5=No blind dial (ATX2)

6=Busy detection (ATX3)

7=Full result codes (ATX4)

Bit 7 Not used

S23 General Bit-Mapped Options: S23 reflects the state of several “AT” commands.

Bit 0 0=Remote DLB disabled (AT&T5)

1=Remote DLB allowed (AT&T4)

Bit 1-3 0=Host interface at 300 BPS

1=Host interface at 600 BPS

2=Host interface at 1200 BPS

3=Host interface at 2400 BPS

4=Host interface at 4800 BPS

5=Host interface at 9600 BPS

6=Host interface at 19200 BPS

7=Host I/F at 38,400 BPS or higher

Bit 4-5 0=Even parity in use

1=Not in use

2=Odd parity in use

3=No parity in use

Bit 6-7 0=No guard tone (AT&G0)

1=No guard tone (AT&G1)

2=1800 Hz guard tone (AT&G2)

3=Not used

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19

Commentaires sur ces manuels

Pas de commentaire

Data-Linc Group DLM4100 Guide de l'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Mise en réseau Data-Linc Group DLM4100