Data-Linc Group DLM4100 Guide de l'utilisateur télécharger pdf (Page 10)

DLM4100 User’s Manual

P/N 161-09977-001B

+MS- Select Modulation – AT+MS sets the modulation and available data rates in the format shown below

AT+MS= a, b, c, d, e, f <CR>

a=Modulation type

B103- Bell 103 (300 BPS)

B212- Bell 212 (1200 BPS)

V21- V.21(300 BPS)

V22- V.22 (1200 BPS)

V22B- V.22bis (1200 or 2400 BPS)

V23- V.23 (1200 Tx/ 75 RX or 75 Tx/ 1200 Rx)

V32- V.32 (4800 or 9600 BPS)

V32B- V.32bis (4800 to 14400 BPS)

V34- V.34bis (16800 to 33600 BPS)

b= Auto detection

0- Automatic Negotiation Disabled

1- Automatic Negotiation Enabled

c= Minimum receive Data Rate (300 to 33600 BPS)

d= Maximum receive Data Rate (300 to 33600 BPS)

e= Minimum transmit Data Rate (300 to 33600 BPS)

f= Maximum transmit Data Rate (300 to 33600 BPS)

Modem Registers

S0 Answer on nth Ring: S0 sets the modem to automatically answer on the nth ring. Setting S0 to 0

disables automatic answer.

Range: 0 to 255

Units: Rings

Default: 0

S1 Ring Count: S1 is a read-only register showing the number of rings detected. If a ring is not detected

within 8 seconds, S1 reset to zero.

Range: 0 to 255

Units: Rings

Default: 0

S2 Escape Character: S2 determines the ASCII escape character. Values of 0-127 select valid ASCII

escape characters; values from 128-255 disable the escape sequence.

Range: 0 to 255

Units: ASCII Character

Default: 43

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 18 19

Pas de commentaire

Data-Linc Group DLM4100 Guide de l'utilisateur Page 10